Showing posts with label basic techniques. Show all posts
Showing posts with label basic techniques. Show all posts

Sliding your fingers on a guitar string is one of the many ways to add flavor to your blues guitar sound. To do a string slide, put your finger on a string and let it glide through until you stop at another fret location. For example (Fig. 1):

Guitar String Slide

You can also do a string slide going backward rather than forward the higher registers of the guitar fretboard. For example (Fig. 2):

String Slide (Backwards)

Guitar String Slide

You can slide from, say, fret 3 to fret 15 on the same string, forward or backward. The only limitations to where you want to stop when sliding your fingers on the strings are the fretboard and the blues guitar scale you are playing.


-->>CONTINUE TO LESSON 4: THE VIBRATO

<<--RETURN TO LESSON 2: HAMMER-ON AND PULL-OFF

In guitar playing, the term "hammer-on" refers to putting a finger on a higher fret on a string that is currently being played on a lower fret. For example, while playing the 6th string on the 3rd fret, you can put your finger on the same string but on the 5th fret as if you're to "hammer" the string (Fig. 1); hence, the term "hammer-on".

Guitar Hammer-on

Here's how a guitar hammer-on looks in actual guitar-playing:

Guitar Hammer-on

On the other hand, the term "pull-off" refers to removing a finger positioned on a string on a certain fret; hence, to "pull-off". For example, while playing the 6th string on the 5th fret with your ring finger, remove your ringer from its position so that your index finger will assume the position of the string being played. See Fig. 2:

Guitar Pull-off

Here's how a guitar pull-off looks in actual guitar-playing:

Guitar Pull-off

-->>CONTINUE TO LESSON 3: THE STRING SLIDE

<<--RETURN TO LESSON 1: THE STRING BEND

The guitar string bend is one of the most commonly used techniques in blues guitar playing. Basically, this technique involves bending a string upwards or downwards on the fretboard.

blues guitar string bend

To do a string bend, place your middle finger on the second string (B) of the third fret. Press on the string and bend it upwards until you're able to hear a change in the tune of the string (Fig. 1). You can also press on the string downwards.

blues guitar string bend

A typical way of executing a string bend is to first play a string and then bend the same string on the next two or three frets. In guitar tab format, it will look like this:

String Bend in Guitar Tab Format

Here's how it looks on a guitar:

blues guitar string bend

Blues guitar involves a lot of string bends. Better get those fingers bending steel strings as much as you can so that your fingers will get used to this technique.

-->>CONTINUE TO LESSON 2: HAMMER-ON AND PULL-OFF

<<--RETURN TO HOMEPAGE